Avon Flyers Forum Home | |
https://www.avonflyers.ns.ca/cgi-bin/Forum/yabb2/YaBB.pl
Avon Radio Control Flyers Discussion Area >> General Board >> turbo cad https://www.avonflyers.ns.ca/cgi-bin/Forum/yabb2/YaBB.pl?num=1420230196 Message started by Fingers on Jan 2nd, 2015 at 4:23pm |
Title: turbo cad Post by Fingers on Jan 2nd, 2015 at 4:23pm
Is there an "easy" way to learn this software (ie tutorial software), or does one just dedicate the hours to play on the screen hoping something seeps into the brain? :wallbash
|
Title: Re: turbo cad Post by waverider on Jan 4th, 2015 at 12:23am
2D or 3D?
2D is easy. draw line straight from a to b use absolute coords to begin use line parallel to at a distance, a lot and perpendicular to line. the snap is very important set snap to end and midpoint to begin with you should be able to draw rectangular shapes with this use the dimension vertical and horizontal. i know you haven't set the scale yet thats lesson 2 |
Title: Re: turbo cad Post by waverider on Jan 4th, 2015 at 12:26am
scale
figure out what fits on papwe in setup set orienation, portrait or landsape what you set as oienation for the cad set same for the print orienation choose scal choose origin... you will have to figure out what to use. try 1, 1 for origina that sets the origin from the bottom left |
Title: Re: turbo cad Post by waverider on Jan 4th, 2015 at 12:28am
if all else fails go to youtube
i learned to play blues guitar from youtube only wish i wasnt tone deaf |
Avon Flyers Forum Home » Powered by YaBB 2.4! YaBB Forum Software © 2000-2024. All Rights Reserved. |