Avon Flyers Forum Home

Avon Flyers Forum Home
https://www.avonflyers.ns.ca/cgi-bin/Forum/yabb2/YaBB.pl Avon Radio Control Flyers Discussion Area >> General Board >> DLE ignition input voltage https://www.avonflyers.ns.ca/cgi-bin/Forum/yabb2/YaBB.pl?num=1349016467 Message started by crash on Sep 30^th, 2012 at 10:47am

Title: DLE ignition input voltage
Post by crash on Sep 30^th, 2012 at 10:47am

With much discussion at the field about the max voltage that can be put into dle ignitions. I checked DLE's home page and found that the max volts allowed is 7 volts.Check out this link.

http://www.dlepower.net/custom.asp?id=10

Title: Re: DLE ignition input voltage
Post by Yak Man on Sep 30^th, 2012 at 12:07pm

Well then a 6.6 volt life pack with a full charge is 3.6 volts per cell. So a full 2S pack may be a bit hot but .2 of a volt shouldn't make that big of a diff. However a reg would take any doubt away.

Title: Re: DLE ignition input voltage
Post by dano on Sep 30^th, 2012 at 4:50pm

I think the specs are inconsistent,(depends where you look).

http://www.dle-engines.com/dleg0055.html