Avon Flyers Forum Home | |
https://www.avonflyers.ns.ca/cgi-bin/Forum/yabb2/YaBB.pl
Avon Radio Control Flyers Discussion Area >> RC Tips and Tricks >> 2.4 on a Heli setup https://www.avonflyers.ns.ca/cgi-bin/Forum/yabb2/YaBB.pl?num=1330283604 Message started by Raptor on Feb 26th, 2012 at 3:13pm |
Title: 2.4 on a Heli setup Post by Raptor on Feb 26th, 2012 at 3:13pm
I have a question , I am changing out to 2.4 on my heli's how are you guys taping the wires from the receiver on the heli's ?
|
Title: Re: 2.4 on a Heli setup Post by Steve Mosher on Mar 13th, 2012 at 7:59pm
Hey Paul,
I have the Rx on a horizontal tray with the antenna pointing toward the rear of the heli. I used some thick CA to glue a couple of small pieces of Nyrod tube to the outide of each frame doubler and ran the antenna inside of them. Holds the antenna in place with no stress on them. |
Title: Re: 2.4 on a Heli setup Post by Raptor on Mar 14th, 2012 at 10:06am
Thank you , I pickup up a piece of plastic from John and tucked it under the battery , then bend it with a heat gun under the from tray , but I will use your idea to secure the leads , Thanks
Paul |
Avon Flyers Forum Home » Powered by YaBB 2.4! YaBB Forum Software © 2000-2024. All Rights Reserved. |